Nylon treatment agent - solve the problem of poor adhesion of nylon material painting

We all know that nylon materials have poor surface physical properties and poor adhesion, and often require special handling before they can be effectively attached. The nylon treatment agent came into being, it can effectively increase the surface adhesion of nylon material, but the production of nylon treatment agent so many manufacturers, in the end a kind of how to make manufacturers feel at ease? I believe that in this respect, Dongguan Yuanya Chemical Co., Ltd. can definitely assure you that the nylon treatment agent is the main product of Dongguan Yuanya. It has been used by the majority of customers in the market, and we have a research and development, production, sales and after-sales service. The entire system, after so many years of accumulated experience, can be said to stand up to the test of our customers.

Nylon treatment agent is used to improve the adhesion to the substrate during the coating of nylon plastics. Nylon materials have poor surface physical properties, low polarity, and often have poor adhesion, and require special treatment before they can be effectively attached. Nylon treatment agents are specially produced for these, have excellent adhesion, can spray any coating (including hand oil, UV varnish, etc.) on the treated nylon substrate. Nylon treatment agent is widely used in many aspects such as household appliances, small commodities, advanced toys, etc. It is easy to operate and can pass various tests.

Physical properties:

1, chemical composition: polymer interface polymer.

2. Density (g/cm3): 0.90.

3, flash point: about 12 °C.

4, Appearance: light yellow transparent liquid.

Instructions:

1. Wipe the nylon material to be treated to remove residual grease or release agent on the surface.

2. Spray or wipe the nylon treatment agent onto the dry film 5-10UM on the material to be treated and let it stand for 5-10 minutes.

3. Apply ink or paint and let stand for 5-10 minutes.

4. Force the coated parts to dry at 80°C for 30 minutes.

Recommended usage and dosage:

1, the full amount: 25% (for **) such as: Y-602: ** = 25:75

2. Adjust the dilution ratio according to the requirements of various different substrates.

Precautions:

1. Avoid contact with the eyes or skin. Inadvertently wash it with plenty of water and soapy water. Seek medical attention if necessary.

2, the product shelf life of 12 months, should be stored in a cool (below 30 °C) dark, well-ventilated place, away from fire.

3, after opening to seal and save in order to avoid failure.